Ráhno Point-7 Carbon+ProKód: 4044/140 4044/150 4044/170 4044/190 4044/220 Zvolte variantu
Při nákupu nad 2000,- Kč
Expedujeme do 24 hodin.
Kamenná prodejna v Praze
Od Roku 2005 stále na stejné adrese
Online od Po do Ne 10-23
Potřebujete se poradit? Jsme na telefonu i chatu od rána do noci.
Detailní popis produktu
|Délka ráhna v cm||Nastavení velikosti v cm||Průměr trubek v mm||Váha v kg|
black team curves.
The needs of a wave boom’s curve is very different from the curve for a slalom boom, just like a slalom boom for strong wind is very different from a boom for light wind slalom – one needs to offer control and the other power. Developing the right curve brings comfort and, respectively, performance.
back end width.
smart balanced design.
We have developed the correct tail width to suit each boom size and its uses. The width of the back end of a boom is very important – the wider, the more power; the narrower, the more control. We have studied each size to fit best the sail sizes it’s designed for.
smart balanced design.
Diameter is another important factor as it does bring comfort to the forearms and saves wasting energy whilst out on the water. At Point-7 we have developed our boom using the Octatube – a carbon tube shape with 8 sides, designed to ergonomically fit the natural shape of the hand when gripping. We vary the diameter used according to the discipline; 25mm for the wave boom, 27mm on the 170-slalom boom, and 29mm on the two larger sizes of the slalom boom.
The stiffness of a carbon boom is also very important, the right mix between reflex and comfort needs to be found. Just as masts have different IMCS, our booms are also being developed to offer the right stiffness to allow comfort in smaller sails sizes, and more reflex in bigger sail sizes.
You can have the lightest and stiffest boom available, but if these main features are wrong then the boom will feel heavy and uncomfortable. The weight needs to be front oriented on the boom, leaving the tail end of the boom light. A heavy tail-end will make a light boom, in general, feel heavier than it really is. This is why we use a taper through to the tail section, the wider diameter allows to have thinner and lighter carbon walls where there is no need for us to grip, but also more stiffness where it is most important.
All our carbon booms are monocoque built, including the tail ends with molded holes. All our carbon booms are tapered giving a thinner diameter in the area you grip while sailing, and a wider diameter on the rear part to allow stiffness and light weight where most needed.
twin pin clips.
Boom double pin clips for a stiffer connection between boom body and tail end, with 2cm adjustments. Different sizes used to best suit the boom size boom head.
The boom head is made to bring the correct synergy with the stiffness of the carbon tubes. Easy automatic fitting to the mast. Moving head tilts according to fitting height on the mast, but does not move from side to side. With very little rope tension, the head will not slip on the mast. Fits RDM adaptors perfectly (included in the 150 model), and the 140 Carbon boom has a dedicated head for only RDM masts
Boom Grip is lightly sanded, anti-slip pro grip: Less strength needed from you for a firm grip on the boom. Easy positioning marks for the harness lines.
To be less bulky in manoeuvres and high winds, the tail end is made to fit inside the boom body in the smaller sized booms: wave 140, 150 and slalom 170. To further reduce the weight and increase the stiffness of the bigger 190 and 210 booms, the diameter of the tail pieces are increased and fit outside the boom body.
Buďte první, kdo napíše příspěvek k této položce.